Our vapor or vapour mounted rim seals on an internal floating roof consists of a continuous seal mounted on the rim of the floating roof and extending to the tank wall, covering the entire primary seal.
Commonly used are (Flip Flop) Wiper seals as vapour mounted primary rim seals for internal floating roof tanks.
Maxwell Continental Tank Serv Engineering has combined over 20 years’ experiences from the past with their research and development, through which it has produced increasingly innovative products for reducing above ground storage tank (AST) emissions.
And it’s not just about the new and interesting, when old technologies and products are to be revitalised or re-used it always can be reviewed and when needed altered to be made more efficient.
Advantages Maxwell Vapor-Mounted Seals
The internal floating roof rim seal design is such that evaporative losses from the stored liquid are limited to losses from the rim seal system and deck fittings (standing storage loss) and any exposed liquid on the tank walls (withdrawal loss).
Next to preventing vapour losses or preventing ingress of rain water the Maxwell floating roof rim seals will be provided as the right seal for every type of above ground storage tank (AST).
Due to years of experience in design, manufacturing and installation we as Maxwell will provide products that satisfy all protection needs.
As recognised by Maxwell Continental Tank Serv Engineering a competitive, cost effective and good working floating roof rim seal should comply to many basic criteria.
Since floating roof rim seal parts are in contact with product, Maxwell will design these parts as product resistant as possible.
When having a floating roof rim seal mounted in the open, many material parts are subject to UV exposure and will be designed by Maxwell in UV resistant materials.
During the sliding movement against the tank shell all sliding parts will be designed by Maxwell in wear resistant materials.
While the Maxwell floating roof rim seals are also designed to positively centre the floating roof, our design will prevent horizontal movements to damage tank features like rolling ladders, gauge poles, pipe drain systems and more. During the horizontal movements of the internal floating roof our Maxwell floating roof rim seals are designed to damp these horizontal roof movements to a minimum.
Based on our Maxwell design input the adequate working range of the floating roof will be analysed and the rim seal designed will be evaluated to comply to the working range needed by the current tank configuration or any local laws or guidelines. This means we can provide each seal with a working range compliant to your request, from API where a range of +/- 4″(102-mm) is required or per EEMUA 159 or NEN-EN 14015 where a tank seal working range of -X/+3X might be requested.
For the secondary rim seals Maxwell will provide the secondary rim seal exposed material in a configuration, which will meet or exceed any requested fire-retardant level.
In the meantime, Maxwell will always design any secondary rim as low as possible to allow more filling capacity.
The most commonly used Maxwell Vapor Mounted Seals or vapour mounted seals either used as a single or combined configuration are:
• MRS-60 Primary Wiper Seal
All Maxwell IFR Rim Seals can be combined with;
• MRS-70 Secondary Wiper Seal